H3C Technologies H3C Intelligent Management Center User Manual
Page 623
609
Options include: Informational, Warning, Minor, Major, and Critical.
4.
Select the check type. Options include Device, Interface, Link, Aggregate Link, Configuration
Segment, and Jython Script.
5.
Do one of the following:
{
If you select Interface or Configuration Segment, go to Step 6.
{
If you select Link or Aggregate Link, go to Step 10.
{
If you select Device, go to Step 13.
{
If you select Jython Script, go to Step 17.
6.
Set the start and end identifiers.
7.
In the Start Identifier text box, enter the start identifier of the interface to be checked, for example,
enter interface *.
8.
In the End Identifier text box, enter the end identifier of the interface configuration, for example,
enter # or !.
The rule checks the configuration segment according to the start and end identifiers.
9.
Go to Step 13.
10.
Set the start and end identifiers.
11.
In the Start Identifier text box, enter the start identifier of the link configuration.
12.
In the End Identifier text box, enter the end identifier of the link configuration.
For example, enter # or !.
The rule checks the configuration segment according to the start and end identifiers.
13.
Select the check target from the Check Target list.
Options include Latest backup running configuration, Latest backup startup configuration, and
Display command output.
14.
Do one of the following:
{
If you select Latest backup running configuration or Latest backup startup configuration, go to
Step 17.
{
If you select Display command output, go to Step 15.
15.
Enter a display command in the text box next to Command, or select a display command as
follows.
a.
Click Select next to the text box.
b.
In the window that displays, enter a partial or complete display command in the text box next
to Name of Display Command, all qualified display commands are displayed in the Command
List.
c.
Click the radio button of the desired display commands.
The selected commands are displayed in the text box next to Command.
The variables such as the dollar sign ($) are not supported. For example, a display command
cannot contain ${ip address}.
16.
Select a vender from the Vendor list for the rule.
The rule only checks the devices of the selected vendor.
17.
Select the device series to be checked.
18.
Click Select next to Device Series.