H3C Technologies H3C Intelligent Management Center User Manual
Page 539
525
The Device Type dialog box appears.
The Device Type dialog box contains two sections. The Series List section contains a list of all
vendor specific device series in IMC. The top section under Device Type provides two options for
filtering the Series List.
9.
Do one of the following:
To display the device series for a specific vendor, select the vendor from the Vendor Name list in
the top section of the Device Type dialog box, or
To display a specific device series, enter a full or partial device series name in the Series field.
10.
Click Query to apply your filter to the Series List.
11.
Click the device series name you want to adapt this configuration template to.
An expanded list of all device types under the device series name you selected appears.
12.
Click the checkbox to the left of the devices you want to adapt this configuration template to.
13.
Click OK.
14.
Enter a description for the configuration template in the Description field.
Adding a description that uniquely identifies the function of the configuration template is a
valuable aid that supports the correct deployment of configuration templates. Consider using the
devices to which the template is applied and what the template contains, if using a segment
template type. For segment configuration templates, consider naming the template by the type of
function or commands contained within the template.
15.
Enter the contents of your configuration template in the Content field.
Variables are supported in configuration templates. If you use variables in a configuration
template, you are prompted for the variable values when you deploy the configuration template.
The variable format is ${variable name}. For example ${ip address} is a valid variable where ip
address is used as the variable name. When you deploy the configuration template, ${ip address}
is replaced by the IP address you define.
16.
If you select the CLI Script option from the Template Type list, you can add configuration template
commands in the Content field by using a table.
•
Command: Enter the command to be configured.
•
Response Prompt: Response of the command lines.
•
Prompt Condition: Select the response type, Error Prompt or Successful Prompt.
•
Action: Click Add to enter another command, and click Delete to delete the corresponding
command.
17.
Click Change to Advanced Mode link to switch to the advanced mode, and enter the configuration
template commands in the Content field.
Any blank spaces before or after variable names are omitted. For example, IMC converts
${ paramName } to ${paramName}. A variable name cannot include spaces ( ), dollars signs ($)
or curly braces ({}).
18.
Click OK.
If you click Add on the Configuration Templates page, and select Add CLI Script from the popup
menu, you can also enter the Add Configuration Template page with the default Template Type as
CLI Script.