H3C Technologies H3C Intelligent Management Center - Manual (Page 591)

577
{
If you want to modify the CLI Script information, click the Modify link to the left of the CLI Script
section, and then go to Step 5.
{
If you do not, go to Step 9.
5. To modify the CLI Script information:
{
If you clicked the checkbox to the left of CLI Script when this device was added, go to Step 6.
{
If you want to deploy the CLI script to this device, click the checkbox to the left of CLI Script,
and then go to Step 6.
{
If you do not want to deploy the CLI script to this device, click the checkbox to the left of CLI
Script, and then go to Step 9.
6. Select the CLI script file folder that contains the CLI script file you want to deploy from the Folder list
of the CLI Script section.
7. Select the CLI script file name you want to deploy from the File Name list of the CLI Script section.
8. If the CLI script file content includes variables, input the parameters of the CLI script file in the Please
input parameter field of the CLI Script section.
9. Do one of the following:
{
If you want to modify the Device Basic Information, go to Step10.
{
If you do not, go to Step14.
10. Modify the MAC address for this device as needed in the Match Criteria: MAC address field of the
Device Basic Information section.
11. Modify the current IP address for this device as needed in the Match Criteria: Current IP address
field of the Device Basic Information section.
You should input at least one of the match criteria. To match a zero-configuration device, enter the
MAC address. To match a device that has been added to IMC, enter its MAC address, current IP
address, or both.
12. Modify the target IP address for this device as needed in the Target IP Address field of the Device
Basic Information section.
13. If you want to modify the stack member ID for this device, enter the new stack member ID in the
Stack Member ID field.
CAUTION:
You can assign stack member IDs only to the zero-configuration devices. Otherwise, auto deployment can
fail.
14. If you want to modify the Configure Device Information, see " Modifying the configure device
information ."
Modifying the configure device information
To modify the configure device Information:
1. Do one of the following:
{
If you clicked the checkbox to the left of Configure Device Information when this device was
added, go to Step 2.
{
If you want to configure this device information, click the checkbox to the left of Configure
Device Information, and then go to Step 2.
{
If you do not want to configure this device information, click the checkbox to the left of
Configure Device Information, and then go to Step 8.