H3C Technologies H3C Intelligent Management Center - Manual (Page 344)

330
{
Click the check marked box to the left of Save device's current configuration if you want
reboot the device without saving its current configuration.
{
Leave the checkbox checked if you want to save the device's current configuration.
3. Click Reset.
4. Verify that the device reset was successful by checking the Reset Device dialog box for reset results.
5. Click Close to close the Reset Device dialog box.
Saving configuration
You can save the configuration of routers, switches, and wireless devices by using the Save Configuration
option located in the Device Management section of the right navigation tree of the Device Details page.
This function is equivalent to executing the Save command on devices.
To save the configuration of the selected device from the Device Details page:
1. Click the Save Configuration link located under the Device Management section of the right
navigation tree on the selected device's Device Details page.
For information on navigating to a device's Device Details page, see "
Viewing devices with Device,
IP, and Topology Views " and " Viewing devices with custom views ."
2. Click OK to confirm your request to save the configuration for the selected device.
Environment monitor
To view or modify the environment information for the selected card, or reset the card:
1. Click the Environment Monitor link located under the Device Management section of the right
navigation tree on the selected device's Device Details page.
For information on navigating to a device's Device Details page, see "
Viewing devices with Device,
IP, and Topology Views " and " Viewing devices with custom views ."
The Environment Monitor page appears.
Environment monitor list
• Frame No.: Contains the frame No.
• Slot No.: Contains the slot No. that specifies the slot where the board resides.
• Type: Contains the type of the board.
• Status: Indicates the state is normal, upper indicates that the temperature exceeds the upper
threshold, and lower indicates the temperature is under the lower threshold.
• Value(cent.): Contains the temperature of the board.
• Upper Limit(cent.): Contains the upper threshold for the board temperature.
• Lower Limit(cent.): Contains the lower threshold for the board temperature.
• Modify: Contains the link for modifying the environment parameters, including upper limit, lower
limit and critical limit.
• Reset: Contains a link to reset the card and the Save device's current configuration option.
If the Environment lists multiple entries, the following navigational aids may appear:
{
Click to page forward in the Environment list.
{
Click to page forward to the end of the Environment list.
{
Click to page backward in the Environment list.