Links – H3C Technologies H3C Intelligent Management Center User Manual
Page 634
620
4.
Click the name link of (Cisco)No delay on interfaces-CatOS in the Rule List to enter the Rule Details
page.
a.
Checks whether the device is a Cisco device. If not, the device is not checked. If yes, goes to
the next step.
b.
Checks whether the device series belongs to Device Series. If not, the rule does not check the
device. If yes, the rule goes to the next step.
c.
Reads the Latest backup running configuration file on the device to check the configuration
segment starting with interface and ending with !. If the configuration segment does not
contain delay, the device conforms to the compliance policy. If the configuration segment
contains delay, the rule goes to the next step.
d.
Executes the no delay command to remove the interface delay configuration and ends the
check.
e.
Repeats the previous steps to check all the devices in the check task.
Links
The (HPA) Duplex status rule checks whether the duplex modes on the devices on the two ends of a link
are the same. If not, the check result is displayed to notify the administrator.
1.
Navigation Service > Compliance Policy.
a.
Click the Service tab from the tabular navigation system on the top.
b.
Click Compliance Center on the navigation tree on the left.
c.
Click Compliance Policy under Compliance Center on the left navigation tree.
The Policy List appears.
2.
Input Link status in the Name field, and click Query.
3.
Click the name link of Link status in the Policy List to enter the Compliance Policy Details page.
For more information about the Compliance Policy Details page, see "
information about a compliance policy
."
4.
Click the name link of (HPA)Duplex status in the Rule List to enter the Rule Details page.
a.
Checks whether the device is a Hewlett Packard device. If not, the device is not checked. If yes,
the rule goes to the next step.
b.
Checks whether the device series belongs to Device Series. If not, the rule does not check the
device. If yes, the rule goes to the next step.
c.
Performs link calculation. If a device is not directly connected to any other device, the device
is not checked. If only one device exists or no devices are directly connected, the rule ends the
compliance check on all devices. Otherwise, the rule calculates links, reads description for
interfaces connecting the two devices, and uses interface + interface description as a start
identifier. Then the rule goes to the next step.
d.
Reads the Latest backup running configuration files on the devices on the two ends of a link,
and checks whether the configuration segment starting with interface + interface description
and ending with # contains duplex.
If neither configuration segments contain duplex, the two devices use the auto negotiated
duplex mode and conform to the compliance policy. Otherwise, the rule goes to the next step.
e.
Checks whether the configuration segments contain duplex auto. If at least one configuration
segment contains duplex auto, at least one device adopts the auto negotiated duplex mode,
and the two devices conform to the compliance policy. Otherwise, the rule goes to the next
step.