H3C Technologies H3C Intelligent Management Center - Manual (Page 543)

529
string configuration for each location and then deploy that configuration template to devices by
location.
A CLI script template type creates a CLI configuration file, which is then applied to the device
through telnet.
7. To copy, delete, or add devices to a configuration template, do one of the following:
Select the folder you want to copy the configuration template to from the Folder list, or
Select the devices you want to remove in the Applicable Devices field and click Delete Model, or
Click Select Model to the right of the Applicable Devices field to add devices.
The Device Type dialog box appears, containing two sections:
The Series List section contains a list of all vendor specific device series in IMC.
The top section under Device Type gives you two options for filtering the Series List.
8. Do one of the following:
To display the devices series for a specific vendor, select the vendor from the Vendor Name list in
the top section of the Device Type dialog box, or
To display a specific device series, enter a full or partial device series name in the Series field.
9. Click Query to apply your filter to the Series List.
10. Click the device series name you want to adapt this configuration template to.
An expanded list of all device types under the device series name you selected appears.
11. Click the checkbox to the left of the devices in which you want to adapt this configuration
template.
12. Click OK.
13. Modify the description for the configuration template in the Description field as needed.
14. Modify the contents of the configuration template in the Content field.
Variables are supported in configuration templates. If you use variables in a configuration
template, you are prompted for the variable values when you deploy the configuration template.
The variable format is ${variable name}. For example ${ip address} is a valid variable where ip
address is used as the variable name. When you deploy the configuration template, ${ip address}
is replaced by the IP address you define.
15. If you select the CLI Script option from the Template Type list, you can modify configuration
template commands in the Content field by using a table.
• Command: Enter the command to be configured.
• Response Prompt: Response of the command lines.
• Prompt Condition: Select the response type, Error Prompt or Successful Prompt.
• Action: Click Add to enter another command, and click Delete to delete the corresponding
command.
16. Click Change to Advanced Mode link to switch to the advanced mode, and modify the
configuration template commands in the Content field.
Any blank spaces before or after a variable name is omitted. For example, IMC converts
${ paramName } to ${paramName}. A variable name cannot include spaces ( ), dollars signs ($)
or curly braces ({}).
17. Click OK.